240 Volt 100 Amp 3 Phase (Hubbell no. 4100R9W or comparable

480 Volt 60 Amp 3 Phase (Hubbell no. 460R7W or comparable

A•T Mobile requires a Dedicated Circuit or Disconnect Box of either a 100 amp 3 phase 240 volt service or a 60 amp 3 phase 480 volt service.

Power must be located within 100 feet of bottling site.  one of the following winery supplied receptacles should be installed and properly wired prior to bottling.

If needed A•T Mobile will provide a "Pig Tail" for the winery to connect as needed

A•T Mobile will not be held responsible for any wiring that needs to be done to your power supply.  A Certified Electrician should be used in making any electrical changes.  if your Winery does not have the necessary power to operate the truck, a generator can be rented from your local equipment dealer at the winery's expense.  A 60 KW, 240 volt 3-phase 60 amp is needed.

Maximum overall label height is 6 inches      

Minimum overall label height is 1/2 an inch.

Minimum label width is 2 inches        

Center of label roll core is 3 inches.

Important: Front and back labels for tapered bottles must be printed on separate webs in order to allow for adjustment for skewed labels on a separate basis.

Front and back labels on separate webs or front and back labels on same web.  Same web is preferred when not using tapered bottles.

Labels must be wound industry standard #4 (labels face outside roll with left edge or label leading)             

A minimum of 1/8 inch spacing between labels for electronic sensing

Label rolls must not exceed 14 inches in overall diameter in order to avoid excessive waste